您现在的位置:网站首页答辩论文工学论文机械论文

控制系统数字仿真与CAD课程报告

  • 简介:(论文 字数:1465 页数:8)摘要: 控制系统是为了达到预期的目标而设计的,它是由相互关联的部件按一定的结构构成的,它能提供预期的系统响应。控制工程以反馈理论和线形理论为基础,并综合应用了网络理论和通信理论的有关概念。因此,控制工程并不局限...
    • 请与管理员联系购买资料 QQ:5739126
  • 论文简介
  • 相关论文
  • 论文下载

(论文 字数:1465 页数:8)摘要: 控制系统是为了达到预期的目标而设计的,它是由相互关联的部件按一定的结构构成的,它能提供预期的系统响应。控制工程以反馈理论和线形理论为基础,并综合应用了网络理论和通信理论的有关概念。因此,控制工程并不局限于任一单个学科,而是在航空工程、化工工程、机械工程、环境工程、土木工程、电气工程等工程学科中都有同样广泛的应用。由于受控系统日益复杂,以及人们对获得最优性能的兴趣与日俱增,近十余年来,控制系统工程变得愈来愈重要。

Summary: A control system consisting of interconnected components is designed to achieve a desired purpose. It is an interconnection of components forming a system configurantiong that will provide a desired system response. Control engineering is based on the foundations of feedback theory and linear system analysis,and it integrates the concepts of network theory and communication theory.Therefore control engineering is not limited to any engineering discipline but is equally applicable to aeronautical,chemical,mechanical,environmental,civil ,and electrical engineering.Due to the increasing complexity of the system under control and the interest in achieving optimum performance,the importance of control system engineering has grown in the past decades.

关键词: 负反馈,相角裕量,超调量,调节时间

Key words: Negative feedback Phase margin Overshoot Settling time

目录

1.设计比例控制器Gc(s)=K,是相位裕量达到45度
2.绘制系统的Bode图,检验是否满足要求
3.绘制单位阶跃响应曲线,计算超调量和调节时间

引言:
对系统设计而言,首要的任务是设计能达到预期控制性能的系统结构配置。系统通常的结构配置如图所示。评判一个控制系统时,首先应该看它是否稳定;如果系统是稳定的,还应该进一步考察它的相对稳定性。相对稳定性的一个指标是相角裕量,相角裕量给出了保证系统稳定的最大冗余相角。相角裕量越大,系统的稳定性就越好。利用Bode图可以方便 的估计系统的相对稳定性指标。

查看评论 已有0位网友发表了看法
  • 验证码: