洗衣机波轮注射模具设计(完整一套设计,有说明书:论文,图纸) A0 装配图.dwg A1 凹模.dwg A2凹模套板.dwg A2动模固定板.dwg A3凸模.dwg 任务书.doc 波轮说明书.doc 目 录 录...................................................................................................... ...........................................1 势...................................................................................................3 性...........................................................................................5 目...................................................................................................... .............................7 理...................................................................................................... .....20 计...................................................................................................... .....................22 计...................................................................................................... ......................22 计...................................................................................................... ...............................23 计...................................................................................................... ...............23 画...................................................................................................... ...........................24 料...................................................................................................... .....................24 文...................................................................................................... .....................28 结...................................................................................................... .....................30 【摘要】本文是关于注塑模具的计算机辅助设计,分为注射摸具的设计和摸具仿真装配,前者是对凸模,凹模,浇注系统, 脱模机构,顶出机构的设计,选择标准零件,设计非标件;然后再用CAXA实体设计和PRO/E做成3D实体,并用CAXA实体设计进 行模具的仿真装配,然后输出成动画. 【Abstract】This article focuses on the computer aided design for the plastics injection mold, and it is divided into the design of whole mold and the stimulating assembly process of the mold. The former shows the design process for the punch, the die, the pouring system, the demolding mechanism, and the pin-lift arrangement; it also includes some choices for these standard components. The latter creates the 3D solid models with CAXA and PRO/E software systems respectively. Then it performs the stimulating assembly process. 参考文献 |
洗衣机波轮注射模具设计(完整一套设计,有说明书:论文,图纸)
- 上一篇:毕业设计 切管机设计
- 下一篇:升降电梯驱动系统设计及控制电路设计(完整一套设...
查看评论
已有0位网友发表了看法