您现在的位置:网站首页答辩论文工学论文电子论文

MAX2754芯片简介及应用电路设计

  • 简介:(页数:14字数:4224)摘要: MAX2754为单片、带线性调制输入的压控振荡器(VCO),适用于2.4GHz至2.5GHz ISM频段,尤其适合直接采用频率调制发送结构的FSK调制系统。这个芯片除了标准的频率调整输入外还可以接收线性调制输入。频率调整范围从1145MHz至1250MHz ...
    • 请与管理员联系购买资料 QQ:5739126
  • 论文简介
  • 相关论文
  • 论文下载

(页数:14字数:4224)摘要: MAX2754为单片、带线性调制输入的压控振荡器(VCO),适用于2.4GHz至2.5GHz ISM频段,尤其适合直接采用频率调制发送结构的FSK调制系统。这个芯片除了标准的频率调整输入外还可以接收线性调制输入。频率调整范围从1145MHz至1250MHz (1/2 LO),可支持输入频率高达110MHz。VCO是基于Maxim专有的单片集成VCO技术,所有的VCO单元集中在一块芯片上,包括变容二极管和电感器。
MAX2754线性调制输入提供了一种在调谐输入电压范围内以固定的调制灵敏度直接对VCO调频的方法。在保证的频率范围内,典型的频率偏差是-500kHz/V,线性度为±4%。输入电压的调整范围是+0.4V至+2.4V,振荡器的频率由工厂预置,确保频率限制范围。振荡器信号经过输出放大器(内部匹配到50 )缓冲,以提供高输出能力、并且使振荡器与负载阻抗变化相隔离。
MAX2754的工作电压为+2.7V至+5.5V。该芯片提供一种数控关断模式,可实现灵活的电源管理。关闭后,电源电流减小到0.2µA。工作模式下能量消耗也只有41mW。
MAX2754采用8引脚µMAX®封装,是尺寸最小、最完备的2.4GHz直接调制VCO解决方案。
Abstrac
The MAX2754 self-contained, linear modulation, voltage-controlled oscillator (VCO) is intended for use in the 2.4GHz to 2.5GHz ISM band, particularly for FSK modulation systems that utilize a direct frequency-modulation transmit architecture. This device features a linear modulation input in addition to the standard frequency tuning input. The frequency tuning range of 1145MHz to 1250MHz (1/2 LO) also supports an IF up to 110MHz with low side LO. The VCO is based on Maxim’s proprietary monolithic VCO technology, where all VCO components are integrated on-chip, including the varactor and inductor.
The MAX2754 linear modulation input offers a means to directly FM modulate the VCO with a constant modulation sensitivity over the tuning voltage input range. Typical frequency deviation is -500kHz/V which is linear to ±4% over the guaranteed frequency limits. The tuning input voltage range is +0.4V to +2.4V and the oscillator frequency is factory adjusted to provide guaranteed limits. The oscillator signal is buffered by an output amplifier stage (internally matched to 50Ω) to provide higher output power and isolate the oscillator from load impedance variations.
The MAX2754 operates over a +2.7V to +5.5V supply range. This device also provides a digitally controlled shutdown mode to permit implementation of sophisticated power-supply management. In shutdown, the supply current is reduced to 0.2μA. Even when active, power consumption is a modest 41mW. The MAX2754 is packaged in the miniature 8-pin μMAX to offer the world’s smallest, complete 2.4GHz directmodulation VCO solution.

关键字: MAX2754 压控振荡器 线性调制 特性曲线 调频偏差
Key words: MAX2754 VCO Linear Modulation Characteristic Frequency-modulation deviation

1 芯片介绍 …………………………………………(4)
1.1 芯片特点………………………………… (4)
1.2 引脚配置 …………………………………(5)
1.3 工作电路图…………………………………(5)
1.4 芯片规范参数 ……………………………(6)
2 电路的各种特性 …………………………………(6)
2.1 直流特性 …………………………………(6)
2.2 交流特性 …………………………………(7)
2.3 交流特性(延续)…………………………(7)
2.4 典型工作特性………………………………(8)
3 应用电路说明 ……………………………………(10)
3.1 管脚描叙……………………………………(10)
3.2 详细说明……………………………………(11)
3.3 线性调制……………………………………(11)
3.4 输出缓冲器…………………………………(11)
3.5 应用资料……………………………………(11)
3.6 系统测试……………………………………(13)
4 芯片包装 …………………………………………(13)
4.1 包装资料 ……………………………………(13)
5 结论 ………………………………………………(14)
6 参考文献 …………………………………………(15)

1.1芯片特点:

*完整的压控振荡器由芯片内电感器和变容二极管调谐元件构成。
*支持1/2本机振荡器应用保证在1140mhz-1250mhz调谐范围内。
*调制线性内部±4%。
*精确的调制增益(500khz/反之亦然)。
*低相位噪声(137dbc/赫兹在4mhz偏移量)。
*单一的电源操作+2.7v到+5.5v。
*低电流停工方式。
*微型8脚引线包装。
1.2芯片应用:
HomeRF WLAN
Bluetooth
2.4GHz无绳电话
2.4GHz无线数据收发器



1.3引脚配置:
零件 工作范围 管脚包装
MAX2754EUA -40°C到+85°C 8 μMAX


Maxim综合产品:
按照价格、交货,和订购须知,请直接联系Maxim / Dallas,在1 - 888 - 629 - 4642或访问网点www.maxim ic.com。

查看评论 已有0位网友发表了看法
  • 验证码: