五寸软盘盖注射模具设计(完整一套设计,有说明书:论文,图纸) 侧滑块.dwg 定模板.dwg 动模板.dwg 拼块1.dwg 拼块2.dwg 锲紧块.dwg 塑件.dwg 型腔.dwg 型芯.dwg 装配模.dwg 设计说明书.doc 型腔工装工艺卡.doc 型芯工装工艺卡.doc 目 录 ….3 ……6 …6 .12 19 …23 ……..24 ……..25 …….26 ……..26 摘要: 在综合分析塑件结构,使用要求。成型质量和模具制造成本的 抽芯机构,使塑件能一次成型。设计了相应的的侧向分型抽 芯的注射模。并介绍了模具的工作过程 Based on the comprehensive analysis on the plastic part’s strcture service require-ment, moulding quality and mouding quality and mould manu facturing cost. Acorresponding injection mould of internal side core pulling was designed.By adopting the mulit-direction and multi- combination core-pulling .acorresponding injection mould of interal side core pulling was designed,the working process of the mould was in-troduced. Key words:injection mould ,medialcoe pulling. 主要参考文献 |
五寸软盘盖注射模具设计(完整一套设计,有说明书:论文,图纸)
- 上一篇:毕业设计 切管机设计
- 下一篇:文具整理盒外塑料模具设计(完整一套设计,有说明...
查看评论
已有0位网友发表了看法