放音机机壳注射模设计(完整一套设计,有说明书:论文,图纸) 1.A4.dwg 2.A4.dwg 3.A3.dwg 4.A4.dwg 5.A3.dwg 6.A3.dwg 7.A4.dwg 8.A4.dwg 9.A4.dwg 10.A3.dwg 毕业设计装配图.A1.dwg 塑件图1.A3.dwg 毕业设计说明书.doc 工艺.doc 目 录 式...................................................7 择...............................................................7 计.........................................8 计..........................................................11 计...........................................20 结................................................................30 谢...............................................................32 献..............................................................33 放音机机壳注射模设计 芯和复位,模具采用了斜导柱侧向抽芯结构与弹簧抽芯结构相结合,可自动抽芯 复位提高生产力。 inject the mold. construction, for the sake of the solution system pull outing of the bore of a three ,on the sideses core pulling adopted the slanted pillar the plastic direction with were realized , molding tool to pull out the pulling construction and spring coil to pull out the core construction to combine.together, and can automatically pull out the core mould to increase the productivity. 参 考 文 献 学技术出版社出版,1998 |
放音机机壳注射模设计(完整一套设计,有说明书:论文,图纸)
- 上一篇:毕业设计 切管机设计
- 下一篇:纺纱摩擦片骨架注射模具设计(完整一套设计,有说...
查看评论
已有0位网友发表了看法