充电器上盖的注射模设计(完整一套设计,有说明书:论文,图纸) 凹模.dwg 摆钩2.dwg 动模板2.dwg 滑块2.dwg 浇口2.dwg 冷却水管2.dwg 零件图.dwg 凸模.dwg 型心1.dwg 支架装配图88.dwg 说明书.doc 目 录 摘 要 的结构和形状作全面的分析,然后测绘出塑件的尺寸,绘制塑件的零件图,根据塑件的零件图构思出模具的型腔及型芯 的大体形状然后做出详细的零件图。最后对塑件进行模具的设计,通过对模具的浇注系统,成型零件,合模和脱模机构 ,侧抽芯机构等等的设计,最后完成模具的设计。 关键词;注塑模、塑件、型腔、型芯
finishing the study of mold die design. The first step of the mould design of chong dian qi’s front casing is giving the entirely analysis of the mold part and then measure the dimension of mold part, protracts the part drawing of mold part and conceives the general shape of the mould cavity and mould core of the mould, and then draws the particular parts picture. At last, process the design of mould for mold part, through mould’s cast system, molding parts, closing mould, doffing mould organization, and side drawing core organization etc. Finally, finish the design of mould. Keyword : mold die, mold part, mould cavity, mould core. 参 考 文 献 |
充电器上盖的注射模设计(完整一套设计,有说明书:论文,图纸)
- 上一篇:毕业设计 切管机设计
- 下一篇:成型娶酰胺(尼龙)软管接头的注射模具(完整一套...
查看评论
已有0位网友发表了看法