[1] K. Hikita, Development of weight reduction technology for door trim using foamed PP, JSAE Rev. 23 (2002) 239–244. [2] K. Weiss, Thin-wall: reducing the weight, size and cost of portable electronics by reducing the wall thickness of enclosures, Mater. Des. 21 (2000) 51–55.[3] B.H. Min, A study on quality monitoring of injection-molded parts,J. Mater. Process. Technol. 136 (2003) 1–6. [4] B. Nardin, K. Kuzman, Z. Kampus, Injection molding simulationresults as an input to the injection moulding process, J. Mater. Process. Technol. 130/131 (2002) 310–314. [5] L.-S. Turng, M. Peic, Computer aided process and design optimizationfor injection moulding, J. Eng. Manuf. 216 (2002) 1523–1532. [6] Moldflow Co., MPI/FUSION: understanding dual domain technologyand how use it, Moldflow White Paper, 2000. http:// www.moldflow.com. [7] D. Jarusa, J.W. Summers, A. Hiltnera, E. Baera, Weld line strength ofpoly(vinyl chloride)/polyethylene blends, Polymer 41 (2000) 3057–3068. [8] N. Mekhilef, A. Ait-Kadi, A. Ajji, Weld lines in injection-moulded immiscible blends: model prediction and experimental results, Polymer36 (1995) 2033–2042. [9] D.H. Chun, Cavity filling analyses of injection molding simulation:bubble and weld line formation, J. Mater. Process. Technol. 89/90(1999) 177–181. [10] C. Li, Optimum cooling system design of a free-form injection moldusing an abductive network, J. Mater. Process. Technol. 120 (2002)226–236. [11] L.Q. Tang, C. Chassapis, S. Manoochehri, Optimal cooling systemdesign for multi-cavity injection molding, Finite Elem. Anal. Des.26 (1997) 229–251
|